QR 1550 class by Wuiske Models

Items used:

ESU 58820 LokSound 5 DCC Micro decoder

DCCSound Premium speaker for the Wuiske 1550 & 2100 class models

To remove the body from the chassis:

1) Swing the bogies through their motion to locate two screws on the underside of the chassis near the fuel tank.

2) Back the screws off by about 4mm. Full removal is optional.

3) Gently pull the body up and partially off from the chassis.

4) The body's lighting is attached to the chassis via two looms. One can disconnect the body from the chassis if preferred.

5) Place the decoder on the speaker and fix in place with double sided tape.

6) Wire the two brown speaker wires to the two speaker drivers, such that they're wired in parallel and in phase.

7) Place the speaker and decoder assembly on the chassis, such that one of the two body mount screws passes through the cutout in the speaker.

8) Position the speaker on the chassis and fix with Kapton tape or equivalent.

9) Remove the DC 8 pin PCB and plug the decoder in.

9) There may not be sufficient room for the white plug at the long hood end. It is suggested to cut the plug and hardwire an extra 60mm of wire from the motherboard to the yellow, blue and green wires.

10) Refit the body once the decoder has been tested, fixing back in place via the two body mount screws.